China Carbon Molecular Sieve Co.,Ltd.manufactures Lithium molecular sieve for oxygen

index

CMS for N2

CMS for CH4

pruducts

services

 price

 service life

 psa and vpsa

 首页

 公司简介

 使用说明

 产品

 服务

 在线订单

 english

LiX molecular sieve

 

 

Japanese

Spanish

Italian

 Russrian

 Arabic

Franch

 Portug

 Korean

German

China Carbon Molecular Sieve Co., Ltd. has long been engaged in the research and productes Lithium molecular sieve for oxygen production

People hope that carbon molecular sieve has high nitrogen yield, long service life and low raw gas consumption. In order to increase the nitrogen yield, the diameter of the carbon molecular sieve(CMS) is reduced. People make carbon molecular sieve with a diameter of less than 1.1mm. However, in the process of using carbon molecules(CMS), if the oil and water in the air enter the carbon molecular sieve, the carbon molecular sieve(CMS) absorbs water and oil, which will gradually reduce the nitrogen yield and service life of the carbon molecular sieve and the nitrogen generator. In addition, the flushing of the airflow will cause The pulverization of carbon molecular sieve will also reduce the nitrogen yield and service life of the nitrogen generator. Therefore, the carbon molecular sieve(CMS) must be vibrated and compacted when it is loaded into the adsorption tower of the nitrogen generator. In the process of use, the air entering the carbon molecular sieve in the adsorption tower of the nitrogen generator is usually first dried and purified to control the oil in the air. And the water content is below 3ppm.
The carbon molecular sieve itself should also have high strength, suitable water and oil resistance. Thereby improving the service life of carbon molecular sieve. However, carbon molecular sieves with small diameters have lower strength than carbon molecular sieves with large diameters, and carbon molecular sieves
(CMS) have a shorter service life.
China Carbon Molecular Sieve Co., Ltd. found that increasing the nitrogen yield of carbon molecular sieves can also be achieved by selecting appropriate pure raw materials. The lower the ash content of inorganic salts in the raw materials for carbon molecular sieves, especially sodium ions The smaller the content, the higher the nitrogen yield, water resistance and oil resistance of the carbon molecular sieve, and the longer the service life. Secondly, the raw material powder should be crushed and ground to less than 3 microns. The finer the raw material powder, the higher the strength of the carbon molecular sieve
(CMS). The higher the nitrogen production rate and the higher the water and oil resistance of the carbon molecular sieve, the longer the service life. Therefore, the nitrogen yield of our carbon molecular sieve with a diameter of 1.2-1.8mm is the same as that of a carbon molecular sieve with a diameter of less than 1.1mm, but the strength of the carbon molecular sieve(CMS) is greatly improved and the service life is long.
Finally, China Carbon Molecular Sieve Co., Ltd. adopted a suitable coating process to improve the water resistance and oil resistance of the carbon molecular sieve
(CMS) and increase the service life of the carbon molecular sieve.
China Carbon Molecular Sieve Co., Ltd. uses pure raw materials that do not contain inorganic salt ash, advanced hole adjustment technology, advanced grinding and coating processes to produce carbon with a diameter of 1.2-1.8mm with long service life, high nitrogen yield and low air consumption. Molecular sieve. It has the same nitrogen yield as carbon molecular sieve with a diameter of less than 1.1mm, but the strength is greatly increased and the service life is increased.